Bellingham Real Estate
Blog Home Property Search Relocation Communities Market News Buyers Sellers About Us
  All Listings New Listings Featured Listings Address Search MLS# For Sale By Owner

Posts Tagged ‘Water heating’

How to Prevent Water Damage in Your Home

September 14th, 2011 by Fawn | Posted in Bellingham, Random, Real Estate Questions, Whatcom County | 3 Comments »

Bellingham Real Estate Water DamageLiving in the Pacific Northwest rain can cause potential water damgage in your home but that there are also many other water sources other than rain that can damage you home. Below is a wonderul article courtesy of Jefferson Livingston at Pillar to Post Home Inspection Services to help you educate yourself on potential water damage in your home.

Water damage can come from a variety of sources: storms, flooding, broken water pipes and lines, leaking washing machines, and more. This can lead to mold and odor problems, and worse. If left unmitigated, water damage can eventually cause structural damage, which can entail significant costs to repair and can even affect a home’s value.

Prevention is the first defense against water damage. Here are some basics on preventing water damage and its effects:

  • Water supply lines to and from washing machines and dishwashers should be regularly checked for leaks. Both the hoses themselves and the connections should be examined. Even a small leak can cause water damage over time, so any leaks should be repaired immediately. If the laundry room is located on the main floor or above, damage to the floor and ceiling below can be especially problematic.
  • Tank-style water heaters are prone to leaking, especially after several years of use. Over time, the bottom of the tank can rust out, causing a serious leak. Ideally, an overflow valve should be installed that will conduct leaking water to a pipe that will drain either outside or to an appropriate interior drain.
  • Another common source of water leaks is the icemaker supply line; this should be checked as well.
  • Be aware that pipe leakage can occur inside the walls or ceiling and may be impossible to detect visually before damage has already occurred.
  • Gutters and downspouts should be checked to ensure that water is flowing away from the home’s foundation. Make any adjustments, and check the flow again using water from a garden hose.
  • Water leak detectors can be installed at floor level near water heaters and interior air conditioning units. Simple, inexpensive wireless models are widely available and will sound an alarm when water is detected on the floor near these appliances.

For more information on home inspection services, Jefferson Livingston at Pillar to Post would be happy to help. www.PillartoPost.com/nwwa.com

Enhanced by Zemanta

Keep Your Home Safe This Winter

December 2nd, 2010 by Fawn | Posted in Random | 1 Comment »

Home SnowThe temperature outside at my house is 30 degrees this morning which must mean Winter is near. Below are some tips courtesy of Jefferson Livingston at Pillar to Post Home Inspections on how to keep you home safe and warm in the cold temperatures.

Seal Drafts - Seal holes, cracks, and openings in your home to stop the flow of heat through the walls and ceiling.

Keep Your Pipes Pumping – Pay less for hot water by insulating pipes. This will also decrease the chance of pipes freezing.

Clean Those Gutters – Once the leaves fall, remove them and other debris from your home’s gutters so that rain, melting snow, and ice can drain properly.

Bundle Up – If you have a tank style water heater, wrap it in an insulation blanket to prevent needless energy use.

Turn It Down – Many conventional water heaters are set too high. Try lowering the temperature setting a notch. A lower setting may be hot enough. When you leave the house, turn down your thermostat so you aren’t paying for heat you don’t need – or consider installing a simple programmable thermostat that will adjust the temperature automatically.

Furnace Care – A simple way to keep your home warm while cutting down on energy waste is by replacing your furnace filters or cleaning them as needed. Follow the manufacturer’s instructions.

Insulate – One of the most effective ways to keep a home warm is to install adequate insulation. This is especially true in attics and crawlspaces. Insulation helps keep the home cool in summer and warm in winter.

Use Energy Star® – Energy Star qualified products help you save energy and reduce greenhouse gas emissions. The Energy Star label can be found on more than 40 different kinds of products for the home including heating and cooling equipment, electronics, lighting, and appliances  

Source: Pillar to Post Home Inspections

Enhanced by Zemanta

The Johnson Team
510 Lakeway Drive
Bellingham, WA 98225

Info@johnsonteamrealestate.com - Toll Free- 1-888-713-3056 - Phone: (360) 733-3030